A tankless unit heats water as it flows, so its failures are about ignition, sensing and scale rather than a tank of stored heat.
What goes wrong
It will not fire. The unit needs adequate flow before it lights; a low-flow tap or a clogged inlet filter can stop ignition entirely. Gas supply and the igniter are the next suspects.
Error codes. The display usually narrows it: a code for flame failure is a different job from a code for overheat or blocked venting. Writing the code down before calling is the single most useful thing a homeowner can do.
Cold water in the middle of a shower. Capacity and flow sharing between outlets is often the cause rather than a fault — several draws at once exceed what the unit is rated for.
Hot-cold cycling. Scale on the heat exchanger restricts flow, the unit overheats, shuts down, cools, and repeats. In hard-water areas this is the most common pattern.
No hot water at one tap only. That is usually the fixture or a flow restriction, not the heater.
Descaling is a service, not a repair
On a tankless unit, minerals from the water collect on the heat exchanger. Descaling circulates a cleaning solution through the unit to dissolve them. It is the maintenance job that prevents the cycling and shutdowns, and it is different from flushing a storage tank.
What to expect
Most tankless failures are repairable: sensors, igniters, valves and filters are replaceable parts. Where descaling does not restore flow, the exchanger's condition decides whether repair still makes sense. A short call with the model and the code usually settles which path it is. If the next step is a different unit rather than a repaired one, tank to tankless covers what changes in the switch.