A tankless unit heats on demand, so it has no stored hot water to run out of. What it does have is a set of conditions that must be met before it will fire at all.
It will not light
These units ignite only once they sense flow. A clogged inlet filter, a tap below the activation threshold, or a fixture restricting flow can stop ignition with nothing wrong inside the heater. If flow is adequate, the next suspects are gas supply and the igniter — which is why a tankless diagnosis always asks what else in the house is running.
What the display is telling you
Flame failure, overheat and blocked vent are three separate jobs that share one screen. Writing the code down before calling is the most useful thing a homeowner can do, and the model name from the cover helps nearly as much. A code is a clue rather than a diagnosis; it narrows the checks, not the answer.
Scale, at this district's hardness
Rancho Cucamonga's supply runs a little over the hard line — about 7.3 grains per gallon on the district's 2025 figure — and that mineral content plates the inside of the heat exchanger over time. Flow narrows, the unit overheats, shuts down, cools and restarts: hot-cold cycling in the shower, or a flow fault on the display. Descaling dissolves the layer and is servicing rather than repair.
The retrofit question
Many tankless units replace an old tank in the same space, and the conversion leaves traces — venting adapted to an existing flue, a gas line sized for a different appliance, a condensate path finished quickly. Repairing the unit without noticing those can chase the same fault twice, so the vent and gas arrangement get looked at alongside the heater.
Where repair ends
If the exchanger is too scaled to restore flow, the failed part is the expensive one. That is the honest moment to compare descaling and repair against replacement, rather than promising a fix that will not hold.
Coverage: Rancho Cucamonga, any hour.