A tankless unit is compact, efficient and considerably less forgiving of a mountain winter than the tank it replaced.
Freeze protection runs on electricity
The unit protects its exchanger with a small heater that needs power. While the electricity is on, that is sufficient for a sheltered installation. When the supply fails in freezing weather, protection stops, and an exchanger with water in it can split within hours. That is the single failure mode worth planning around here.
Draining before a closure
Manufacturers publish a drain-down procedure for each model: isolating valves, a purge port, and compressed air or gravity to clear the waterway. Doing it properly before a property is left is what makes the difference between a spring restart and a replacement. The procedure is model-specific, so it is confirmed rather than assumed.
Cold inlet, lower output
At elevation the incoming water is colder, and a tankless unit's capacity is rated against a temperature rise. The same appliance that serves a valley house comfortably delivers noticeably less hot water here. When a unit "cannot keep up" in winter, the finding is often arithmetic rather than a fault.
Low flow and the firing threshold
A low-flow fixture or a partly closed valve can keep the unit below its activation flow. Testing at the unit separates that from a genuine ignition or sensor fault.
Scale, on whatever the water carries
No supplier is verified for these streets, so the exchanger is inspected rather than assumed clean. Descaling is routine maintenance on a mineral supply and urgent once capacity starts dropping.