A tankless unit is fussy about its inputs: enough flow, enough gas, clear exhaust and live power. On a well-fed mountain property, all four can be marginal at once.
Flow and the firing threshold
These units need a minimum flow before they light. On a system with a pressure switch and a pump, flow at a distant tap can fall below that threshold even though water is running. A clogged inlet filter does the same thing. Testing at the unit separates a supply problem from a heater fault.
Pressure that is not steady
A well system cycles between cut-in and cut-out pressure. A tankless heater reading that swing can short-cycle, and the water temperature follows the cycling rather than holding. Where the pressure tank is waterlogged, the heater is usually the messenger rather than the cause.
Scale from an unknown supply
Untreated or mineral-rich water coats the exchanger, and capacity drops before anything fails. Water that used to be hot at full flow starts arriving cooler, then the unit trips on overheat. Descaling is the repair; a scaled exchanger left long enough is not repairable.
Freeze protection needs power
Tankless units protect themselves with a heater that runs on electricity. In an outage, that protection stops — and on an exposed mountain installation, that matters within hours. Isolating and draining during a long outage is the practical answer, and it is worth knowing where the drain valves are before you need them.
Propane and altitude
Where the fuel comes from a tank, the supply has to be sized for a unit that fires hard, and an appliance set for the wrong fuel or the wrong elevation will misbehave in ways that look like a fault. Both are checked before parts are blamed.