A gas appliance at altitude runs in conditions its rating plate was written for a valley, and the first cold season after an installation is when the difference shows.
Combustion air at elevation
Thinner air means less oxygen per cubic metre, and a burner adjusted for sea level runs rich. Yellow tips, soot on the flue collar and a flame that lifts are all air-related before they are part-related. An appliance rated or derated for the elevation is the correct answer; a shuttered air intake adjusted by trial and error is not.
The pilot after a cold season
A pilot that lights and dies when the knob is released is a thermocouple or sensor fault, and months of disuse make it more likely rather than less. A pilot that will not light at all usually points at the supply — a propane tank that is low, a regulator that has failed, or air in a line that has been off.
Venting, snow and downdraft
The flue termination has to stay clear of snow and out of the wind shadow of the roof. A heater that works until the first heavy fall and then trips is describing its vent, not its burner. The clearance and the cap are checked as part of the service.
Flame colour as a reading
Blue and steady is right. Yellow, lifting or sooty means exhaust and air are wrong, and the unit stays off until the venting is sorted. In a tightly sealed cabin, that check also covers where the combustion air comes from.
Smell gas
Leave, then call the utility — for a tank supply as much as a main. That is not a diagnostic step.