An electric heater has fewer parts than a gas one and gives clearer signals, which makes most calls here a matter of narrowing rather than guesswork.
Three symptoms, three places to look
Nothing hot anywhere: the supply, the upper thermostat or the upper element. Hot then cold within a minute: the lower element, since the top of the tank heats first. Water at the wrong temperature against the dial: a thermostat. Each points at a different part and a different check.
The reset that keeps popping
The upper thermostat's reset is a safety device. It trips because the tank overheated — a stuck thermostat, a failed element, or a unit switched on without water in it. Resetting it repeatedly without finding the cause is how a small repair becomes a burnt-out element.
Supply on a mountain circuit
Long service runs, older panels and voltage that sags under load all show up as weak heating rather than none — slow recovery, elements that fail early, a breaker that holds until the tank calls for heat. That is electrical work and belongs with a licensed electrician, not a plumbing part swap.
Air in a drained system
Where a tank was drained and refilled, air in the top of the tank has to be bled from a hot tap before the element is energised. An element that runs dry destroys itself in seconds, and it is the most expensive easy mistake on this appliance.
What the visit establishes
Element condition, thermostat calibration and the state of the supply. None of those is diagnosable from a phone call, and the call is used to decide what to bring.