On a property with a well, the heater shares its world with a pump, a pressure switch and often a generator or an inverter. That makes the supply the first thing to check, not the last.
Is it the heater or the supply?
A tripped breaker, a blown fuse or a pump that has stopped can all read as "no hot water". If the pump is running and the pressure is normal, the supply is likely intact and the heater is the suspect. If nothing on that side is working, the heater was never the problem.
Elements and the pattern they make
Nothing hot anywhere points at the supply or the upper element. Hot for a minute and then cool points at the lower element, because the top of the tank is heated first. That single distinction tells a technician which half of the unit to open.
Reset buttons and why they trip
The upper thermostat's reset pops when the unit overheats, usually because an element has failed or a thermostat is stuck closed. Pressing it back without finding the cause simply schedules the next trip.
Long runs and voltage
Where the heater sits far from the panel, a marginal connection or an undersized run shows up as a heater that works weakly rather than not at all — slow recovery, elements that fail early. That is electrical work, and it is quoted as such.
Off-grid and backup arrangements
An inverter or generator that was sized for the house may not carry a resistive heater at full draw. Where that is the arrangement, the timing of the heating cycle matters as much as the wiring, and it is worth describing when you call.