An electric heater that has sat through a closed season is rarely "broken" in the usual sense. It has usually been switched off, left full, or restarted in the wrong order.
Restarting a drained tank
An element that is energised with no water around it burns out within seconds. If the tank was drained before the property was closed, the water has to be back and the tank full — air bled from a hot tap — before the breaker goes on. Getting that order wrong is the most common way a stored tank is destroyed in a single afternoon.
Restarting a tank that was left full
Left full and unheated in a cold room, the risk is frost rather than the element. A tank that froze has usually split, and the water on the floor when the supply returns is the evidence. Where it did not freeze, a thermostat that sat idle for months can stick, and the upper reset may need pressing once.
The two-element pattern
No hot water at all points at the supply or the upper element. Hot water that fades after a minute points at the lower element. On a property with a single electric heater, that distinction decides whether the visit is a part or a supply check.
Where there is no gas at all
Some properties run entirely on electricity, which puts the whole hot water load on the panel. A heater that trips its breaker under load, or recovers slowly, is describing the circuit as much as the appliance, and a marginal connection at altitude is worth checking before the unit is condemned.
What is not diagnosable by phone
Element condition and thermostat calibration need a meter. The visit establishes them; the call only narrows which half of the tank to open.