A replacement is a decision before it is an appointment. Most calls arrive at it one of three ways, and only one of them is urgent.
The three ways in
The tank has failed. Water at the base or weeping at the seam means the pressure vessel, not a fitting, and that ends the repair path.
The repairs have stopped paying. One failed part on a sound tank is a repair. A second or third failure inside a year is a pattern, and the visits start costing more than the parts do.
The unit is old and the next failure is queued. This is the planning case, and it is the one worth deciding before a leak chooses the timing.
Why the shell is different from every other part
Elements, thermostats, thermocouples, igniters, valves and dip tubes can all be replaced. The tank cannot be sealed, patched or welded to hold under pressure. Once the shell is the failure, the only honest answer is removal — and the leak grows while the decision is being avoided.
What the swap involves
The old unit is isolated, drained and disconnected. Getting it out is part of the job, and in a garage alcove or a tight closet it can be the slower half. The new unit is set, strapped, connected, filled and tested, with the venting and clearances it requires.
Same type, or a change
Staying with the same type reuses the venting, gas line and circuit, which keeps the job to a removal and a swap. Changing from a tank to a tankless unit touches all three: venting material and termination, gas capacity, and often electrical supply. That does not make it a bad choice — it makes it a different job, and the difference shows up in scope long before it shows up in a price.
What this page will not do
It publishes no price, no duration and no warranty term, because none has been supplied as a standing fact. What a replacement costs depends on the unit, the venting and how hard the old one is to remove, and those are worked out from the job itself.