A heater that died while the property was empty usually died for one of two reasons, and the difference decides what has to be replaced alongside it.
Frost, or the long slow failure
A tank that froze splits — the shell is not built to hold ice expanding inside it. A tank that failed from age weeps at a seam or at the base with no frost involved. The second looks the same as the first once the water has drained and dried, so the fittings and the pipework around the unit are inspected before anything is ordered.
Water damage is answered first
A split tank found weeks later means water went somewhere — subfloor, insulation, the frame of a wall. Replacing the heater before that is understood puts a working unit back into a wet cavity. The replacement is scheduled with that in mind.
Matching the property, not just the old unit
Type, fuel, venting and pressure rating. Where the old unit was installed for a different building standard or a fuel that is no longer available at the property, matching it exactly may not be possible or sensible — the venting and supply are checked first.
Cold inlet at elevation
Incoming water here runs colder than on the valley floor, so a like-for-like swap can leave a household short of hot water even though the appliance is new and correct. Where that matters, the capacity is the part that changes, not the brand.
The haul
These are properties where a tank is carried rather than rolled in on a dolly. That is priced and planned with the job.