A replacement that would be a two-hour decision in the valley becomes a specification exercise at 4,193 feet, because the appliance has to be right before it is carried up.
The derating plate, not just the model
Two units of the same model can be configured for different elevations. What matters is the rated input after derating and the venting the unit is approved for. A replacement chosen only by tank size and price can be the wrong appliance for the altitude it is going into.
What the old installation tells you
The flue diameter, the gas line size, the clearance to combustibles and the way the unit is strapped are all evidence of what will fit. Where the previous unit was installed for a different standard, copying it exactly may reproduce a fault rather than a solution.
Failure that ends the discussion
Water at the base, a seam that weeps under pressure, a shell split by frost — those are vessel failures. Parts do not address them. The decision is not whether to replace but what to replace with.
Removing at altitude
Access decides the schedule: stairs, snow, a narrow doorway, a utility closet built around the old tank. The removal route is measured on the visit, and the haul is part of the job rather than a surprise on the day.
County line, permit practicalities
The community is unincorporated and straddles the Los Angeles and San Bernardino county line, so the authority for a given address depends on which side it falls. Permitting is confirmed per property rather than assumed, and the installation is scoped accordingly.