A storage tank is a short list of parts doing a simple job: hold water, heat it, release it safely. Nearly every failure is one of those parts announcing itself.
The parts that fail, and how they announce it
Elements and thermostats on electric units produce the half-warm tank — one element gone, the other still working, so the water is never quite cold and never quite hot enough.
Thermocouples and pilots on gas units fail as a flame that will not stay lit once the knob is released.
Relief valves weep or stick. A dripping valve is the safety device working, not a nuisance to cap, and the reason it opened needs checking.
Dip tubes crack with age and let cold water into the hot draw, so the tank is hot and the tap never is.
The shell fails at the seam or the base, and that is the one failure no part changes.
Sediment, and what this district's water does
Rancho Cucamonga's supply is hard enough to leave a mineral layer — the district's 2025 report puts it about 7.3 grains per gallon, just over the hard line. On a tank floor that layer insulates the burner or element from the water: recovery slows, hot water runs out sooner, and trapped water under the crust pops and rumbles as the heater fires. Removing it is servicing, and it is the cheapest thing that can be done for an older tank.
When the tank is finished
Water at the base with nothing wet above it, or beading at the seam, means the pressure vessel has started to give. It cannot be sealed, and it grows. That finding converts a repair call into a replacement, and pretending otherwise is how people pay twice.
What is replaceable
Elements, thermostats, thermocouples, gas valves, dip tubes, relief valves and drain valves. The tank itself is not.
Coverage: Rancho Cucamonga, answered at any hour.