Two complaints sound identical on the phone and are not: the equipment has failed, and the equipment was never sized for what the business now asks of it.
Not enough, versus not working
A restaurant that runs cold halfway through service, a salon where the second wash goes tepid, an apartment building where the top floor complains at seven in the morning — those are capacity and recovery problems. The heater can be working exactly as designed and still be the wrong equipment for the demand.
A unit that has stopped firing, is leaking, or is tripping its controls is a repair. Those get diagnosed first because the fix is concrete.
Look at the draw pattern before the parts
How many outlets run at once, whether there is a recirculation loop, whether a mixing valve sits between the heater and the tap, and whether the complaint is at one fixture or everywhere. A single cold tap in a building with hot water elsewhere is rarely the tank.
The installation constrains the answer
Larger equipment needs more gas and more air, and an existing flue or supply line sized for the original unit becomes the limit on what can replace it. Electrical supply and the physical space matter too. Those constraints are part of the diagnosis, not an afterthought once a unit is chosen.
Downtime is the real question
On commercial work the practical decision is what can stay running while the repair happens. That is worked out on the call and on site, not promised from a page. No contract terms, maintenance agreements or response guarantees are published here, because none has been supplied.
Scale at this district's hardness
The water matters more at this scale, not less. The district's reported hardness is moderate, but a kitchen drawing hot water continuously is exactly where a mineral layer turns into a recovery problem, and where scale in a tankless exchanger shows up as a flow fault during the busiest hour.
Coverage: Rancho Cucamonga, phone answered any hour.