On a well-fed property the leak and the pressure are two questions, and the second one is the reason leaks recur.
Shutting down is the first step, and it is not always a valve
A municipal service has a valve at the meter. A well property may not, and the fastest way to stop flow is often the pump itself — the breaker or the pressure switch. Knowing that before the water is spreading matters more than knowing which part failed.
Pressure that is set too high
Well systems run on a pressure switch, and a switch set high, or a failed expansion tank that lets pressure swing, stresses every joint in the house. A heater connection that weeps, a relief valve that drips, a union that will not stay tight — those can all be symptoms of the supply rather than the heater.
Where it is coming from
Top connections and nipples corrode quietly and run down the jacket. The relief pipe discharges when pressure or temperature climbs. The drain valve seeps. The tank itself weeps at a seam or from the base, and that one is terminal. Water arriving at the floor is the last place it reached, not the first.
Water that looks like a leak
Condensation on a cold tank, a dripping pump fitting above and a roof or plumbing leak can all end up in the same pan. Sorting them out takes minutes and changes the whole job.
What this means for the visit
The repair is usually a fitting, a valve or a part. When the tank is the source, the visit becomes a removal — and on a mountain property that is planned rather than improvised.