At altitude, an installation question that never comes up in the valley does: what happens to this appliance when nobody is here?
A heated room and an unheated one are different jobs
Equipment installed in a conditioned space is protected from frost by the house itself. Equipment in a shed, a garage or an unheated utility room is not, and the installation has to account for that — insulation on the pipes, a drain-down arrangement, or a unit whose own freeze protection has power.
Choosing for intermittent occupancy
Where a property stands empty for weeks, stored hot water costs nothing to keep once the tank is up to temperature and standby loss is modest, while a tankless unit that must keep itself warm through a freeze depends on continuous power. Neither is universally right; the occupancy pattern decides.
Sizing without a utility record
No water supplier is verified for these streets, so inlet temperature and water condition are checked on site rather than assumed. Colder incoming water at elevation means a given unit delivers less hot water than its valley rating, and sizing that ignores it produces a heater that is always just short.
Venting and combustion air
The flue must suit the unit and the room, and a tightly built or heavily insulated cabin needs an air supply for combustion. Both are decided before the unit is ordered, not adjusted afterwards.
Access and removal
How the new unit arrives and the old one leaves is part of the scope. On a mountain property that is measured on the visit.