Why Your Water Heater Stopped Heating — and What to Check First
A no-hot-water call almost always narrows to three places. How the fuel type and the way the failure arrived point at the likely cause.
When a water heater stops heating, the useful question is not "what is broken" but "how did it break". A unit that died between one shower and the next and a unit that has been getting weaker for a month are usually failing in different places.
Start with the fuel
Gas. The flame is the story. If the pilot will not stay lit when you release the knob, the thermocouple is the usual suspect — it is the part that proves a flame exists and holds the gas valve open. If the pilot will not light at all, check whether other gas appliances are working before anything else, because then it is the supply and not the heater.
Electric. Power is the story. A tripped breaker that resets and stays on points at the heater; one that trips again points at a fault inside it. If power is fine and the water is only lukewarm rather than cold, suspect one of the two elements — most tanks have an upper and a lower, and losing one leaves you with half a tank of hot water, not none.
Which side that is decides where the work goes: gas water heater repair for the flame and venting, electric water heater repair for the elements and breakers.
Then look at the pattern
Sudden, total failure is usually electrical or ignition.
Gradual decline is usually scale or sediment: the heater is working, but heat is going into a mineral layer instead of the water. Water heater maintenance covers what removes that layer, and the noise it makes first is described in popping and rumbling in the tank.
Hot at first, then cold often means a cracked dip tube, which sends cold water into the hot draw.
What you can check safely
The breaker, the pilot, and whether other gas appliances work. Nothing that involves opening a gas line, draining a tank, or testing a live circuit — those belong to someone equipped for it, and an element test on an old tank can turn a repair into a leak.
When to stop
If the tank is wet, or you can smell gas, stop diagnosing. Water at the base of the tank means the shell, and gas means the utility first. Otherwise, the fuel type plus the pattern is enough to make the call useful.